![]() ![]() ![]() On the inside where the metal frame is still bare there is a trim piece that comes about 6-7" too long and in black or white. Beetle Beetle Window Parts Beetle Popout Window Parts product categories for all your VW and volkswagen parts from Custom and Commercial Air-Cooled VW parts. Once you've found the center spot, drilled and attach your window,Īttach your latch to the frame at the rear with the window shut and the latch in the closed position, make sure that the glass is in its proper place evenly and snug and the latch should fall into the position where it should be attached. The bar is threaded to hold the screws in place. The pop-out assembly is set in place at the body and the screw plate is slid in at the body behind the back side of the hinge. Correction all 5 holes have to be drilled, and they need to be the same diameter as your screw. (_<- bar with five holes here.īefore you slide the bar into place use a permanent marker to mark where to drill your holes. The hinge should line up, and come together like this. Once you have it in place either tape it down or have some one hold it from the outside because it can and may fall out (happened to me). ![]() This covers both the passenger and driver side pop-out windows. Double check from the outside to make sure that it is not pushed in unevenly. This is a fresh new screws for both pop outs. If the outer seal is installed it will automatically line up to its location because the seal will fit very snug. Since your car is not pre-drilled, I'm guessing the easiest way to find the location for the hinge holes would be to attach the hinge to the frame and place in its location temporarily. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |